Sharp AR-800 imager, Operation Manual, Page: 63 / 181

59
USING THE EDITING FUNCTIONS
3
Place the original(s) on the original feed
tray or on the glass.
When Using the Automatic Document Feeder
.
After aligning the edges of the originals, set
them face up on the original feed tray and
align the slides to the edges of the originals.
Note: Remove any paper clips or staples from
the originals before placing them on the
original feed tray.
Slides
When Placing the Original on the Glass
.
After lifting the automatic document feeder,
place the original on the glass face down with
the bottom toward you and the left side
centered against the original scale.
.
Close the automatic document feeder slowly
after the original size has been detected.
4
5
Select the desired copy size, exposure,
reproduction ratio and copy quantity.
Press the START key.
Tip: Edges can be erased also in the bypass
copy mode. To do this, set the paper in
the sheet bypass (see page 50), and press
the desired COPY-SIZE key to select the
paper size. If LETTER-R paper is used,
press the corresponding COPY-SIZE key
twice.