page
48
This function is used to select a page of the Memory Registers. Studio 12 Scan Control
has 12 pages.
This function allows to assign the Memory Registers’ operating mode. Operating
modes are And, Or, Flash and Flash or Fader.
These two controls are used to regulate Light Chases’ running speed. Rate
shows the length of the step, Slope the step’s slope time.
This button is on both the Light Chase Control and DMX Unit Control sections, enables
music sync and replaces the RATE parameter which normally regulates the steps of a chase and
the scenes on the Scan Control.
This function allows to select the steps of a Light Chase to run and also (during creation
and modification of a chase) to select the step to be modified.
This function (only enabled when operating in DIRECT mode) is used to create or modify
a chase.
This function, located in both the Light Chase Control and DMX Unit Control sections,
allows to pass to the control mode of the parameters in the Memory Registers.
In the Light Chase Control section, allows to assign a chase to a Memory Register and also to
modify running parameters or enable the required steps of the Chases created.
In the DMX Unit Control section, allows to change the parameters of assignment of a scanner
program in a Memory Register.
This function allows to select the Light Chase to execute, assign to Memory Registers and
Edit.
c h a s e
reg
e d i t
s t e p
m u s i c
ra t e
s l o p e
1
2
3
4 5 6
7
8
9
10
m i n
m a x
0
1
2
3
4 5 6
7
8
9
10
m i n
m a x
0
mode
and
or
flash
p a g e
