GB
appendice
page
47
I
D
F
E
12 - Quick reference
This section sums up the function buttons on the Studio 12 Scan Control and their applications.
This control sets the time for the automatic crossfade between preset A and pre-
set B (GO function - parag. 7).
The LINK function allows to unlatch one or more dimmer channels from presets A and B,
linking their output level only to the GRAND MASTER. It also allows to transfer the new value of
one or more channels to the Memory Registers to carry out easy variations in the stored scenes.
The SOLO function enables flashing in subtractive mode. When enabled, if the channels’
Flash buttons are pressed, all the dimmer channels are switched off except those of the pressed
buttons.
These two buttons switch Preset A and B on or off. When used in “Double Preset”
mode (parag. 3), allow the GO function to be enabled (parag. 7).
This control sets the time for the automatic crossfade from one Memory
Register to another. Only has effect on the registers operating in AND and OR mode.
This function is used to store the scenes created on Presets A and B in a Memory
Register.
The function allows to run Event previously recorded Event.
Pressing GRAB and PLAY simultaneously enables the Event Recording function,
which can also be run in sync with the SMPTE signal, thanks to the connector that the console is
fitted with.
smpte
record
g ra b
p l a y
p l a y
g ra b
re g i s t e r s c r o s s t i m e
s
e
c
o
n
d
s
m
i
n
u
t
e
s
1
2
4
8 16 32
1
2
4
8
of f
m a x
0
A
o r
p s e t
B
g o
s o l o
l i n k
s
e
c
o
n
d
s
m
i
n
u
t
e
s
1
2
4
8 16 32
1
2
4
8
manual presets cross time
of f
m a x
0
