PRODUCT OPERATION & MAINTENANCE PROCEDURE
Model 0101
16
POP-0011– Rev. 5
2.
Place the 7/8" and 1-1/4" or 1-1/2" Open-End Wrenches on the HDD Anvil and hydraulic ram shaft as
shown below.
Note: It may be necessary to turn the anvil with the 1-1/4" or 1-1/2" Open-End
Wrench to align the 7/8" Open-End Wrench onto the flats of the hydraulic ram shaft.
3.
Using the "Flats Method" to torque the anvil, push the Open-End Wrenches together to tighten. Proper
setting for the anvil will be 1 - 2 Flats. See pictures above.
Note: If needed, mark the anvil before
tightening with the wrenches.
Important Note: Using anything other than Open-End Wrenches will not give you the proper torque for
tightening the anvil.
