PRODUCT OPERATION & MAINTENANCE PROCEDURE
Model 0101
18
POP-0011– Rev. 5
Removing the SSD Anvil
The following is a list of tools required to complete this job:
7/8" Open-End Wrench
1-1/4" Open-End Wrench
1.
Unplug the power cord from the electrical outlet.
2.
Open the access door. Using the 1-1/4" Open-End Wrench, place the Open-End Wrench onto the Anvil
and turn both the anvil and hydraulic ram shaft until the two flat edges on the hydraulic ram shaft are
perpendicular to the door opening. This will allow the 7/8" Open-End Wrench to slide onto the flats of
the hydraulic ram shaft. See picture below.
3.
Pull the Open-End Wrenches apart to loosen.
4.
Once loosened unscrew the SSD Anvil from the hydraulic ram shaft by hand.
(Gloves should be worn
for protection against the sharp tines of the anvil.)
Align both wrenches
as shown
