Appendix - Troubleshooting
TPR User Manual
123
Fig. 7: InterCon-NetTool - TPR in the BIOS Mode
The software must be reloaded to the TPR so that the TPR can switch
from the BIOS mode to the normal mode.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Highlight the TPR in the device list.
(You will find the TPR under the filter 'BIOS mode'.)
3. Select
Installation
–
IP Wizard
from the menu bar.
The IP Wizard is started.
4. Follow the instructions of the wizard in order to assign an IP
address to the TPR.
The IP address is saved.
5. Carry out a software update on the TPR; see:
The software will be saved in the TPR. The TPR switches to the
normal mode.
A connection to the TPR Control Center cannot be established
Eliminate possible error sources. First of all, check:
- the cabling connections,
