Sega AV F-ZERO AX, Owner'S Manual

Page: 120 / 252

− 113 −
⑨ Loosen the 2 screws holding the
variable resistor bracket in place,
move the variable resistor bracket,
and adjust the gear engagement for
angle and positioning.
PHOTO 11. 1 h
⑩ Engage and secure the gear at such an angle that the D-cut side of the VR axle is horizontal and
facing downward when the steering unit is not tilted.
⑪ Manipulate the steering unit and make sure the gear is turning smoothly.
⑫ Repeat the above steps in reverse to replace the front and rear steering covers. Take care not to
pinch the wires or overtighten screws.
Note that the screws used to secure the left and right sides of the front steering cover have
different dimensions from the others. Check the screw sizes before installing them.
⑬ Adjust the variable resistor settings on the Volume Settings screen. (see 10-3G.)
⑭ Check to make sure the "STEERING Y" value on the Input Test screen is within the range 78H
± 8H.
② Unplug the Y-axis VR wire
connectors and unfasten the harness
lug holding the wiring in place.
① Perform steps ① through ⑦ under "Adjustment Procedure" to detach the front and rear steering
covers.
HARNESS LUG
CONNECTOR
PHOTO 11. 1 i
REPLACEMENT PROCEDURE