Sega AV F-ZERO AX, Owner'S Manual

Page: 125 / 252

− 118 −
④ Remove the 2 screws securing the microswitch to be replaced and then remove the SW
ADJUST plate and the transparent insulation sheet.
MICROSWITCH
509-6036
PHOTO 11. 2 d
⑤ The wires connected to the old microswitch can be reused for the new microswitch. Remove the
heat contraction tube covering the soldered areas, use the soldering iron to melt the solder, and
remove the wires from the microswitch.
⑥ Solder the wires to the new microswitch. Check the wiring diagram to make sure there are no
mistakes in the wiring. In addition, use a heat contraction tube or other protection to prevent
short-circuiting.
⑦ Attach the SW ADJUST plate and the insulation sheet to the new microswitch and secure them
with 2 screws. Be sure to insert the insulation sheet between the switch and the plate.
⑧ Install the SW ADJUST plate with the new microswitch in the bottom of the steering unit.
Adjust the position of the plate so that the roller on the microswitch's actuator terminal touches
the pin that interlocks with the paddle lever when the lever is not being manipulated, and secure
it with 2 screws.
⑨ Connect the wire connectors and secure the wires with a harness lug.
⑩ Manipulate the paddle lever to make sure the microswitches are turning on and off properly.
Listen for a clicking sound. Also, make sure that the switch does not adhere to the actuator itself
when turned on.
⑪ Replace the front and rear steering covers. Take care not to pinch the wires or overtighten the
screws.
Note that the screws used to secure the left and right sides of the front steering cover have
different dimensions from the others. Check the dimensions of the screws before installing
them.
⑫ On the Input Test screen, check to make sure that the microswitches turn on and off consistently
when the paddle levers are manipulated (see 10-3B).
INSULATION SHEET
SW ADJUST PLATE
SCREW (2)
M3×16, w/flat & spring washers