Sega AV F-ZERO AX, Owner'S Manual

Page: 123 / 252

− 116 −
11 −２ REPLACING THE MICROSWITCHES
Movement in the steering unit's paddle levers is detected by 2 microswitches on the bottom of
the interior of the steering cover. Follow the steps listed below to replace or adjust the position
of these switches.
Note that each of the 2 microswitches on the bottom of the steering unit is linked to the paddle
on the OPPOSITE side in the "PADDLE LEFT/RIGHT" test on the Input Test screen; that is,
the microswitch on the right controls the "PADDLE LEFT" value, and vice-versa. Check to
make sure the switch being replaced or adjusted is the correct one.
The following tools and instruments are required for the following operations:
- 3mm diameter hexagonal screwdriver or wrench
- M4-size Phillips screwdriver
- M3-size Phillips screwdriver
- Nippers
- Cutters
- Soldering iron
- Industrial dryer
① Perform steps 1 through 7 for adjusting the Y-axis VR to remove the front steering cover and
detach the rear steering cover (see 11-1).
② Loosen the 2 screws securing the SW ADJUST plate on which the microswitch to be adjusted in
installed, and then move the SW ADJUST plate to adjust it. Do not loosen the screws on the
side the microswitch is installed on.
PHOTO 11. 2 a
ADJUSTMENT PROCEDURE
SCREW (2)
M3×6, w/flat & spring washers
PADDLE LEFT SIDE SWITCH
PADDLE RIGHT SIDE SWITCH