− 166 −
19 −5 REPLACING THE DIMM BOARD BATTERY PACK
● Do not disassemble the battery pack and the batteries.
If you should fail to observe this instruction, the internal wires and/or
protective devices may be damaged; as a result the safety system may
not function when discharging and recharging, eventually causing an
overheating, fire and explosion. If you should disassemble the
batteries, the generated gases may harm your throat and the negative
plate may overheat and make a fire.
● Do not make an external short circuit of the battery pack and the
batteries.
If you should fail to observe this instruction, the batteries may
overheat, make a fire, and explode.
● Do not fire the battery pack and the batteries.
If you should fail to observe this instruction, the batteries may make a
fire and explode.
Do not leave the battery pack and the batteries nearby the heat source
(fire or heater) or under the intense direct sunlight and flaming sun. If
you should fail to observe this instruction, the batteries may reduce the
service life and in the worst case may overheat, make a fire, and
explode.
● Do not leave the battery pack and the batteries in water or seawater.
Also do not apply water or seawater onto the battery pack and the
batteries. If you should fail to observe this instruction, the internal wires
and/or protective devices may be damaged; as a result the safety
system may not function when discharging and recharging, eventually
causing an overheating, fire and explosion. Also water may be
electrolyzed into oxygen and hydrogen, and eventually the battery's
sealed section may be corroded and the internal liquid may leak.
● Do not solder on the battery pack's terminals.
If you should fail to observe this instruction, the armor may be heated
and melted or the internal wires may be damaged, eventually causing
an overheating, fire and explosion. Also, when the battery's
temperature reaches to 100℃ or more, the battery may leak its internal
liquid due to destruction of its plastic parts (gasket, separator, etc.), or
may overheat, make a fire, or explode due to internal short-circuit.
● Do not insert or connect the battery in a reversal polarity.
If you should fail to observe this instruction, the battery may be
externally short-circuited and eventually overheat, make a fire, or
explode, depending on the device you connect with.
Observe the following precautions when handling the DIMM board's battery pack. Sega cannot
assume responsibility for any problems that arise from handling the battery pack in disregard of
the guidelines set forth in the manual.
WARNINGS AND RESTRICTIONS CONCERNING USE OF BATTERY PACK
Summary of Contents for AV F-ZERO AX
