© 2014
SeaStar Solutions
Optimus Installation Manual, Rev. E
7-6
For Datalink users:
the purge
commands are found on the
Configuration tab of the PCM
interface.
7.
On the CANtrak display, navigate to
dealer menu > Initial Setup
> Steering > purge cylinders
to access the Purge Cylinders
menu.
Figure 7-7.
Figure 7-8.
8.
Select the cylinder you wish to purge and press
>
to enter Purge
Mode.
notIce
When purging you will be required to turn the helm AND maintain
fluid level in the pump reservoir. The pump can empty the reservoir
quickly while purging. When the fluid level in the reservoir drops to
the MIN mark, stop turning the steering wheel and refill the reservoir
to the MAX mark. DO NOT ALLOW THE FLUID LEVEL TO GO BELOW
THE MIN MARK.
If the helm as been steered
since the ignition was turned on
the system will not enter purge
mode. You will need to cycle
power again.
notIce