![background image](http://html1.mh-extra.com/html/seastar/optimum-eps/optimum-eps_installation-manual_1229204126.webp)
© 2014
SeaStar Solutions
Optimus Installation Manual, Rev. E
b-2
note regarding connectivity of tee connectors:
•
When connecting a tee connector to a component always install via the
middle connection (“NODE”).
•
When connecting a tee connector to a CAN Bus harness to connect
components that are far from each other, always install via the male/
female end of the connector (whichever applies).
•
Hand-tighten after the connection is made.
do not
tightly tie down the
tee connectors, as this will create stress.
cm10051: maLe termInator
cm10052: femaLe termInator
tee connectors:
Supplied by several vendors. Appearance may vary - parts are
interchangeable.
BackBone
maLe
femaLe
node IS aLwayS femaLe
B.1.1 CAN Bus Connectors
Figure B-2.
Figure B-3. CM10060: Single tee connector.