© 2014
SeaStar Solutions
Optimus Installation Manual, Rev. E
C-6
C.5 Purge with Datalink
The physical procedure for purging is identical to the steps shown in
section 7.2, but instead of using the display to set the system into
Purge mode, you will use Datalink.
Open the PCM interface and click on the Configuration tab. Find the
Purge and Calibration Commands, as shown in figure C-6.
In step 8 of the purge procedure (section 7.2) use the radio buttons
to set the mode into either ‘Purge port cylinder’ or ‘Purge starboard
cylinder’. To take the system out of purge mode, click the radio
button next to ‘Off’.
Figure C-6.