© 2014
SeaStar Solutions
Optimus Installation Manual, Rev. E
E-2
The Datalink software features an update utility that will automatically
update each component (except the CANtrak display) in your system
to the correct firmware revision for your system type. To use this
feature you need to perform the initial system setup (section 7.1)
before updating the firmware. The instructions for the system setup
will prompt you to check the firmware revision levels, at which point
you will be directed here.
E.2 One-Step System Firmware Update
procedure
1.
Download and install the file updater (section E.1).
2.
Connect your computer to the system and open Datalink (Appendix C).
3.
Choose
control module > update all
to start the utility.
4.
The program will update all the connected components.
5.
Click
yes
at the confirmation dialogs to continue.
6.
When the software reports that the update is complete, close
Datalink and cycle the system power.
7.
You will still need to update the CANtrak display firmware
separately. See section E.6 for instructions.
There is currently no ability to perform an automatic update using
the CANtrak display.
Figure E-2.