SeaBotix Generation 2, Service & Maintenance Procedures Manual

Page: 7 / 101

Step 5 – Phillips #2 Screwdriver
Insert the M4 x 50 Phillips pan head screw into the rear of the
shell. Guide the screw through the gray plastic spacer and
tighten into the float insert.
Step 6
Turn the LBV over onto its starboard side.
Step 7
Lower the port shell and bumper frame assembly onto the LBV
aligning the forward threaded stud and lip under the shell to
back plane as you did with the starboard shell.
Note: be careful not to scratch the view port with the center
crossbar.
Step 8 – Phillips #2 Screwdriver
Insert and tighten 2 M4x20 Phillips pan head screws into the top
of the shell.
Step 9 – 10mm Socket Head Driver
Screw on the 10mm hex nut onto the threaded stud at the front
of the shell.