SeaBotix Generation 2, Service & Maintenance Procedures Manual

Page: 24 / 101

Step 5
Holding the power can with your fingers and using your thumb
to leverage against the back plane carefully pry open the power
can.
Note: you will release the vacuum so do this process slowly
and ensure there is no water that will enter the power can.
Step 6
The o-ring will slip into the power can so locate the o-ring and
wrap around the power can tube.
Step 7 - #2 Phillips Screwdriver
Carefully pull the power can aft to gain access to the forward
Phillips screw holding the port thruster and remove.
Step 8 - #2 Phillips Screwdriver
Allow power can to rest it the starboard end cap and remove the
2 Phillips pan head screws holding the connector for the port
thruster.
Step 9
Remove the port thruster pulling straight off the connectors.