SeaBotix Generation 2, Service & Maintenance Procedures Manual

Page: 5 / 101

Step 6
Lift off the port shell and bumper frame assembly.
Note: be careful not to scratch the view port with the crossbar.
Step 7
Turn the LBV over and place on its port side.
Step 8 – 10mm Socket Head Driver
Repeating a similar process to the port shell remove the 10mm
hex nut at the front of the starboard shell.
Step 9 – Phillips #2 Screwdriver
Remove the M4 x 50 Phillips Pan Head screw from the rear of
the shell.
Note: a gray plastic tube acts as a spacer between the shell and
the float. This spacer will fall out when you remove the screw.
Step 10 – Phillips #2 Screwdriver
Remove the 2 M4 x 20 Phillips pan head screws from the top of
the shell.
Note: again you will have to work around the bumper frame.