SeaBotix Generation 2, Service & Maintenance Procedures Manual, Page: 40 / 101

Step 3 – View Port Sleeve
With the protective sleeve in place slide the view port down onto
the starboard camera housing end cap at an angle.
Step 4
Push down from one angle to the other and feel the view port
click into place.
Step 5 – O-ring Grease
Check the o-rings on the port end cap that they are seated
correctly and have grease on them.
Step 6
Holding in your palms lower the port camera housing end cap
onto the view port from the front edge.
Step 7
Snap into place aligning the clamp bracket with the M6x16
button head screw by the lateral thruster.