SeaBotix Generation 2, Service & Maintenance Procedures Manual

Page: 33 / 101

Step 4 - #2 Phillips Screwdriver
Insert and tighten the 2 Phillips pan head screws on the thruster
connector at the rear of the thruster.
Step 5
Making sure not to pinch any wires push the power can tube into
the groove on the starboard power can end cap.
Step 6 – 3mm Hex Ball Driver
Holding the power can down insert and tighten the 2 M5 button
head cap screws through the back plane.
Note: if they do not go in easily the power can tube is not seated
properly.
Step 7 – O-ring Lube
Put grease on the o-ring liberally and push down against the
starboard power can end cap.
Step 8 – O-ring Insertion Tool
Using the power can o-ring insertion tool and starting from the
back plane side of the power can push the o-ring in-between the
power can end cap and power can tube.