SeaBotix Generation 2, Service & Maintenance Procedures Manual

Page: 11 / 101

Step 5 – Phillips #2 Screwdriver
Remove the 2 M4x10 Phillips pan head screws located in the
middle of the flotation module near the vertical thruster elbow.
Step 6 – 4mm Hex Ball Driver
Remove the 2 M6x16 button head cap screws at the front of the
float securing the camera housing end caps and flotation
module.
Step 7
Holding the back plane with one hand raise the LBV allowing
the flotation module to drop. Remove the flotation module.
Installation
Step 1
Just as the flotation module was removed lift the LBV up to
allow the flotation module to be centered under the LBV. Align
the vertical thruster in the Kort nozzle pressed into the flotation
module.
Step 2 – Phillips #2 Screwdriver
Insert and tighten SLIGHTY the 2 M4x10 Phillips pan head
screws in the middle of the flotation module. This helps to align
the flotation module for the other screws.