Step 10
Check to see if the o-ring has stuck to the back plane and
remove if it has.
Installation
Step 1 – O-ring Lube
Lubricate the o-ring and place in groove on the thruster
connector.
Step 2
Push the starboard thruster onto the 4 pins.
Note: make sure you push on straight so as not to damage the
pins.
Step 3 - #2 Phillips Screwdriver
Pull the power can back to gain access to the forward prop end
cap Phillips pan head screw on the front of the thruster. Insert
and tighten the forward Phillips pan head screw.
Summary of Contents for Generation 2
