SeaBotix Generation 2, Service & Maintenance Procedures Manual

Page: 38 / 101

Step 6
Remove the port shell and bumper frame assembly.
Step 7 - #2 Phillips Screwdriver
Remove the 3 Phillips screws holding the lateral Kort nozzle in
place and remove the Kort nozzle.
Step 8 – 4mm Hex Ball Driver
Loosen but do not remove the M6x16 button head screw
securing the port camera housing end cap to the back plane
and float.
Step 9 – 11/16 Socket
Remove the jacking plug assembly from the port camera
housing.
Note: you will release the vacuum so ensure the area around
the jacking plug is clean and dry.
Step 10
Holding the view port with your fingers pry up with your thumb
and release the port camera housing end cap. Remove.