Sea-doo 230 Series, Operator'S Manual

Page: 120 / 180

MAINTENANCE PROCEDURES
F09D0S0
1
2
TYPICAL
1. Dipstick
2. Oil cap
Boat must be leveled.
Oil level can be checked either with
boat in water or out of water.
If Boat is Out of the Water
If the boat is out of the water and on a
trailer, block the wheels and raise the
bow slightly with the trailer jack (if so
equipped) until the bumper rail is level.
Install a garden hose to the flushing
connector. Refer to
EXHAUST SYS-
TEM FLUSHING
in
MAINTENANCE
PROCEDURES
and follow the proce-
dure.
NOTICE
Never run engine(s) with-
out supplying water to the exhaust
systems when boat is out of water.
Failure to supply water to the ex-
haust systems may severely dam-
age exhaust systems.
NOTICE
Never run engine(s)
longer than 2 minutes. Drive line
seals has no cooling when boat is
out of water.
Procedure Continuation
(Boat Out or In Water)
It is of the utmost importance to follow
this procedure in order to obtain an ac-
curate reading of the engine oil level.
CAUTION Engine oil may be
hot. Certain components in the en-
gine compartment may be very hot.
Direct contact may result in skin
burn.
1. Ensure engine is at normal operat-
ing temperature.
2. Let engine idle for 30 seconds be-
fore stopping.
3. Stop engine.
4. Wait at least 30 seconds.
5. Pull dipstick out and wipe clean.
F09D0SZ
1
TYPICAL
1. Dipstick
6. Reinstall dipstick, push in com-
pletely.
7. Remove dipstick and read oil level.
It should be between marks.
lmr2007-053-100_a
1. Full
2. Add
3. Operating range
8. If needed, add oil up to have the
level between marks as required.
To add oil, unscrew oil cap. Place a
funnel into the opening and add the
recommended oil to the proper level.
118
______________