MAINTENANCE PROCEDURES
F07E01Y
3
2
1
TYPICAL
1. Flushing connector
2. Quick connect adapter and flushing
connector adapter (optional, not mandatory)
3. Garden hose
3. To flush, start engine then immedi-
ately open the water tap.
CAUTION Certain
compo-
nents in the engine compartment
may be very hot. Direct contact may
result in skin burn. Do not touch
any electrical parts or jet pump area
when engine is running.
NOTICE
Never flush a hot en-
gine. Always start the engine before
opening the water tap. Open wa-
ter tap immediately after engine is
started to prevent overheating.
4. Run the engine about 20 sec-
onds at a fast idle between 4000 -
5000 RPM.
NOTICE
Never run engine without
supplying water to the exhaust sys-
tem when boat is out of water.
5. Ensure water flows out of jet pump
while flushing. Otherwise, refer to
an authorized Sea-Doo Boats dealer
for servicing.
NOTICE
Never run engine longer
than 2 minutes. Drive line seal has
no cooling when boat is out of water.
6. Close the water tap, then stop the
engine.
NOTICE
Always close the water
tap before stopping the engine.
NOTICE
Remove
quick connect
adapter after flushing operation (if
used).
Fuses and Circuit Breakers
The electrical system is protected with
fuses and circuit breakers.
To remove fuse from holder, pull fuse
out. Check if filament is melted.
1
2
A15E0KA
1. Fuse
2. Check if melted
If a fuse is defective, replace by one of
the same rating.
NOTE:
If the entire electrical system
is down, make sure the main battery
cut-off switch is properly turned on,
refer to
CONTROLS, INSTRUMENTS
AND EQUIPMENT
. If the main bat-
tery cut-off switch was already ON,
check the main breaker. See
MAIN
BREAKER
below.
NOTICE
Do not use a higher rated
fuse as this can cause severe dam-
age. If a fuse has blown, the source
of malfunction should be deter-
mined and corrected before restart-
ing.
See an authorized Sea-Doo
Boats dealer for servicing.
Main Circuit Breaker
The main circuit breaker is located in
the engine compartment.
The main circuit breaker protects the
entire electrical system except the au-
tomatic bilge pump.
122
______________
Summary of Contents for 230 Series
