Sea-doo 230 Series, Operator'S Manual

Page: 134 / 180

STORAGE
Exhaust System Flushing
Perform procedure as described in
MAINTENANCE
section.
Exhaust System and
Intercooler Protection
Expel water from the exhaust system
and intercooler (twin 215 and twin 260
engines) as follows:
Using the flushing connectors on jet
pump supports, inject pressurized air
(around 689 kPa (100 PSI)) into system
until there is no more water flowing
from the jet pumps.
smo2008-001-054_a
1. Flushing connector — location may differ
To ease the procedure, a custom hose
can be assembled. See the following
illustration.
smo2008-001-053_a
TYPICAL
1. Flushing connector adapter (P/N 295 500
473)
2. Hose 13 mm (1/2 in)
3. Air hose male adapter
NOTICE
Failure to drain the ex-
haust system may cause severe
damage to intercooler and exhaust
manifold.
Engine Internal
Lubrication
NOTE: Both engines must be inter-
nally lubricated for the storage period.
1. Open the engine compartment lid.
2. Remove storage tray.
3. Remove dipstick.
4. Remove engine cover.
5. Reinstall dipstick.
6. Expel water from the exhaust sys-
tem and intercooler (twin 215 en-
gines and twin 260 engines) as fol-
lows:
7. Remove ignition coils. Refer to
MAINTENANCE PROCEDURE
.
8. Remove spark plugs.
NOTICE
Ensure there is no dirt in
coil holes before removing the spark
plugs. Otherwise, dirt would fall
into cylinder and will damage the in-
ternal components.
NOTE: After loosening the spark
plugs, a coil may be used to remove
the spark plugs. Simply bring the coil
down to spark plug and “hook” it to
then extract spark plug.
smr2006-016-030_a
1. Ignition coil
2. Spark plug
9. Spray XPS LUBE (P/N 293 600 016)
or equivalent, into spark plug holes.
132
______________