Sea-doo 230 Series, Operator'S Manual

Page: 123 / 180

MAINTENANCE PROCEDURES
Ignition Coil Installation
NOTE: Prior to inserting the ignition
coil on its spark plug, apply sealant as
described in
IGNITION COIL LUBRI-
CATION
.
1. Install coil in cylinder head hole.
2. Push the ignition coil down to se-
curely install it on the spark plug tip.
3. Ensure the seal seats properly with
top surface of engine valve cover.
smr2009-032-004_a
TYPICAL
1. Seal properly seated
Exhaust System
Exhaust System Flushing
Flushing the exhaust system and in-
tercooler of each engines with fresh
water is essential to neutralize corrod-
ing effects of salt or other chemical
products present in water. It will help
to remove sand, salt, shells or other
particles in water jackets and/or hoses.
WARNING
Perform this operation in a well
ventilated area.
Proceed as follows:
1. Clean jet pump by spraying water in
its inlet and outlet and then apply a
coating of XPS LUBE (P/N 293 600
016) or equivalent.
WARNING
When operating the engine while
the boat is out of the water, the
heat exchanger in the ride plate
may become very hot. Avoid any
contact with ride plate as burns
may occur.
2. Connect a garden hose to the con-
nector located at the rear of boat on
jet pump support. Do not open wa-
ter tap at this time.
lmo2007-003-030_a
TYPICAL
1. Flushing connector
NOTE: Use an optional FLUSHING
CONNECTOR ADAPTER (P/N 295 500
473) with a quick connect adapter to
ease garden hose installation. No hose
pincher is required to flush engine.
1
F00E05A
2
1. Quick connect adapter
2. Flushing connector adapter
______________
121