MT SBC 01
55
MT SBC 01
available pushbuttons using hand-held programming module
Art. 1251/A.
In this mode, with the video interphone
monitor switched on, it is possible to
cycle through all the connected
cameras by repeatedly pressing the
Generic Actuator pushbutton.
Microswitch “S1” must be set as shown
in
Figure 2
.
2. Actuator with code mode
N.B. Before programming the module, see Table 3:
Compatibility of 1259C.
In this mode, module 1259C can be controlled by means of an
actuator pushbutton with code.
To activate the function, programme
the pushbutton on the Bravo bracket
by means of hand-held programming
module 1251/A and set selector “S1”
as shown in Table 2.
In this mode, with the video interphone
monitor switched on, by repeatedly
pressing the actuator with code
pushbutton, it is possible ONLY to cycle through the cameras
connected to module 1259C with the corresponding address. In the
same system, it is possible to install up to 8 1259C modules with
8 different codes.
Table 2
: Programming in actuator with code mode
The two operating modes described above are alternatives.
3. Mode with switchboard 1998A
In parallel to one of the modes described above, it is possible to
activate the module by means of a Video Call from the switchboard.
The “switchboard” function is made available by connecting the INA-
GND contact to the OUT-OUT terminals of Art. 1998A as shown in
diagram SB2V/018GC on page 108.
N.B. The remote camera module must be connected to the
outgoing Bus line from terminals LM-LM of the switchboard.
Set the switchboard to video mode before making the call.
Each time a video call is made from the switchboard, the monitor
will switch on as soon as the handset is lifted, and the image
displayed will be the one from the first camera connected to module
1259C. At this point, each time a control pushbutton is pressed (see
previous modes) or each time the manual contact is closed, a
camera is activated in sequence as shown in
Figure 4
(hypothesis
of 3 cameras connected).
Figure 4:
Sequential switching of cameras in switchboard mode
Table 3
: Compatibility of 1259C with 1256 or other 1259Cs.
Correspondence of 1259C address –
actuator with code on bracket
DIP 1
1
1
1
1
1
1
1
1
0
0
0
0
0
0
0
0
0
1
0
1
0
1
0
1
0
0
1
1
0
0
1
1
0
0
0
0
1
1
1
1
0
0
0
0
0
0
0
0
0
1
2
3
4
5
6
7
220
Compatibility
with 1256
No, of 1256s
in operation “E”
No. of 1256s in operation “F”
with codes
between 220 and 227
Compatibility
with 1259C
No other
1259C
Only 1259C
in mode 2
with 8 different codes
221
222
223
224
225
226
227
DIP 2 DIP 3 DIP 4 DIP 5 DIP 6
1259C
ADDRESS
Actuator code on bracket
5714C or 5714/CI
DIP-SWITCH
1
2
3
4
5
6
7
8
Figure 3
: Example of setting
address on Art. 1259C for control
by means of actuator code 224.
1
st
Camera
2
nd
Camera
3
rd
Camera
Generic actuator
Actuator
Generic actuator
with code mode
DIP-SWITCH
1
2
3
4
5
6
7
8
Figure 2
: Setting
for generic actuator
