MT SBC 01
17
MT SBC 01
Digital call module Art. 3070/A
INTRODUCTION
The Comelit digital call module Art. 3070/A can be used in Simplebus type systems and
enables you to call interphone users by keying in the code that identifies them. The main
specifications are as follows:
• 32-character alphanumeric display.
• Can be combined with porter modules 3062, 3262 (combined with module 1602) and
3268 (combined with module 4660C).
• STANDARD or INDIRECT CODE operating modes.
• Possibility of changing door lock release time, audio timing and reset wait time on the
porter module.
• ACCESS CONTROL function for opening the door by keying in a pre-recorded
password code.
• PC interface for managing INDIRECT CODE mode by means of RS232 or RS485
serial line.
• Possibility of displaying the graphic interface messages in one of the 9 languages
available.
1) KEY FUNCTIONS
DELETE:
to exit the menu or
cancel the operation
CALL – DOOR LOCK – MENU
SELECTION
2) INSTALLATION OF THE MODULE
For the use of module 3070/A with 3262 (combined with module 1602) and 3268
(combined with module 4660C) see diagram SB/KC on page 118. If using Art. 3062,
refer to wiring diagram CA/EN/109 on page 119.
To prevent any interference caused by electrostatic discharges, it is advisable to screen
the casing as shown in the diagram below.
INITIAL CONDITION
3) USING THE DIGITAL CALL MODULE
3A) CALLING A USER:
Module powered up
and in standby.
ENTER USER
CODE
USER:_ _ 1
TO CALL
If the call
is successful, the message:
OPERATING
EFFECTED
If the call is not
successful;
the message:
CODE
NOT AVAILABLE
Or if the riser
is engaged, the message:
BUSY USER
DISPLAY
DESCRIPTION
OPERATION
Key in the code using
the alphanumeric keypad
of module Art. 3070/A.
EXAMPLE:
calling
a user with code
1.
Press
to send the call.
INITIAL CONDITION
3B) RESETTING A CALL OR A CONVERSATION
Call effected or
conversation in progress.
Press
X
.
The module Art. 3070/A
goes back into standby.
OPERATING
EFFECTED
Or:
COMMUNICATING
ENTER USER
CODE
Module powered with
terminal PR connected to
the - terminal.
Or:
With the module
in standby, press
,
enter the supercode and
confirm by
pressing again.
The module is in
programming mode.
The menus are scrolled
through automatically every
2 seconds.
MAIN
SETTINGS
4) SETTINGS
4A) ACCESSING CONFIGURATION MODE
DISPLAY
DESCRIPTION
OPERATION
INITIAL CONDITION
Configuration mode has
been accessed
(see point 4A).
Porter module Art. 3062 /
3262/ 3268 powered
with terminal PR connected
to the - terminal.
The module is in
programming mode.
The menus are scrolled
through automatically
every 2 seconds.
The porter module is in
programming mode.
MAIN
SETTINGS
4B) SYSTEM PARAMETERS
4B-1) CHANGING THE AUDIO TIMING, DOOR LOCK RELEASE TIME AND RESET
WAIT TIME OF THE PORTER MODULE.
This operation enables you to change the audio timing, door lock release relay closure time
and reset wait time for the porter module at the end of the interphone communication.
