C
onnecting &
Setting Up
English -
27
Step 5 : Connecting the
Power Cord
■
After the current time is set automatically, the
recorder will perform Auto Channel Memory for
about 3 minutes. If power is on before finishing
the Auto Channel Memory process, Auto
Channel Memory will stop.
In this case, do Auto Channel Memory from
MENU
(see page 31).
NOTE
After all connections are complete, plug the power cord
in the wall outlet.
“Auto” appears in the panel display. This means
that the current time is being set automatically
(Auto Program) through the antenna under
connection and also the channel is being set.
The setup may take a few minutes.
When the DVD Recorder operates normally, the current time
is automatically set and displayed in the front panel display.
Step 6 : Preparing the
Remote Control
Install Batteries in the Remote Control
•
Open the battery cover on the back of the remote.
•
Insert two AAA batteries. Make sure that the polarities
(+ and -) are aligned correctly.
•
Replace the battery cover.
If the remote control does not operate properly:
•
Check the po - of the batteries (Dry-Cell)
•
Check if the batteries are drained.
•
Check if remote sensor is blocked by obstacles.
•
Check if there is any fluorescent lighting nearby.
Dispose of batteries according to local environmental
regulations. Do not put them in the household trash.
01002B-R130-XAC-ENG-14-27 2006.2.6 6:40 PM Page 27
