Tel: 886.909 602 109 Email: [email protected]
193
3 Bandwidth menu
·
[BW 30kHz]:
Press [BW]→ [BW 30kHz] and set the bandwidth with the
number keys on the front panel. Select [GHz], [MHz], [kHz] or [Hz] in the
frequency unit menu, or set the reference value with the [↑] or [↓] key or
knob.
· [Special note]: The bandwidth must be set as 150Hz, 300Hz, 600Hz,
1.5kHz, 2.4kHz, 6kHz, 9kHz, 15kHz, 30kHz, 50kHz, 120kHz or 150kHz.
· [Detector]:
Press [BW]→ [Detector] to enable the detector menu,
including: Peak, Average and Real Time.
4
Sweep/Antenna menu
·
[Sweep Cont Single]:
Press [Swp/Ant]→[Sweep Cont Single] to enable
the continuous or single sweeping mode.
· [Sweep Once]:
Press [Swp/Ant]→ [Sweep Once] to sweep once again.
· [Recall Antenna]:
Press [Swp/Ant]→ [Recall Antenna] and soft menus
such as [Head], [Tail], [Page Up], [Page Down], [Done] and
[Delete] will pop up. You can select and recall the saved antenna factor file.
·[Edit Antenna]:
Press [Swp/Ant]→ [Recall Antenna], and soft menus
such as [Add Point], [Delete Point], [Delete All], [Done] and
[Cancel] will pop up. This menu is applied to edit the antenna factor.
·[Save Antenna]:
Press [Swp/Ant]→[Save Antenna] to open the antenna
saving dialog box, where the antenna factor file can be saved.
·[Compass Calibration]:
Press [Swp/Ant]→[Compass Calibration] to
open the calibration function, in which case the electronic compass needs
to be rotated horizontally.
· [Special note]: After pressing [Compass Calibration], the menu
switches to [Stop Calibration], which can be used to stop the
calibration.
·[Magnetic Declination]:
Press [Swp/Ant]→[Magnetic Declination], set
the geomagnetic declination value of the current measurement position.
