72
and that it is not sealed properly. Firmly push down on the
lid to help the seal form or release any built up pressure
and safely remove the lid to check the unit thoroughly.
Make sure the rubber gasket ring is in place, the lid is
securely locked, and that the Valve on top of the lid is set
to the “Airtight” position. Reset the unit by unplugging it.
Wait 10
-
seconds and plug it back in. Program the unit
again.
Both of the above solutions will cause some liquid to have
evaporated and it is recommended to add back in any
liquid that has evaporated otherwise you will keep
encountering the same issue or pressure cooker may not
function properly.
4. Steam is being released
around the rim of the lid
during the pressurizing
sequence. How do I fix this?
Please note that steam escaping from the Valve (3) or
around the lid is normal for the first 5 minutes or so
during the Pressurizing process.
If it continues beyond 10
minutes or steam is still releasing when the timer has
begun counting down it may mean that the Rubber Seal
Ring (18) did not form a tight seal when the Lid (2) was
locked. This can happen to brand new units. Try pressing
down firmly on the Lid (2). This should allow the Rubber
Seal Ring (18) to seal and stop any more steam from
releasing.
If this does not fix the issue, press the KEEP
WARM/CANCEL button and follow the instructions to
release all pressure before removing the lid to check the
Red Float Valve (4) or the Rubber Seal Ring (18). See page
7 on how to install the Rubber Seal Ring (18). Rub a wet
cloth along it to make sure it is clean of debris and it is
smooth. Note that the Red Float Valve (4) is properly
assembled and you are able to pull it up and down with
ease by grasping the Float Valve Seal Ring (16).
Reposition and secure the lid. Start the cooking process
again.
5. Steam is being released
from the Pressure Limiting
Valve (3) during the
This may happen during the initial start
-
up of the
Pressurizing Sequence and is normal. If it continues for
more than 10 minutes, the Valve (3) may not be positioned
