Saeco Cristallo 600 EVO, Use And Maintenance

Page: 51 / 112

English
9
51
DISPLAY Description
1.5.1.
The “ECO” mode is activated after some minutes of inactivity which can be set by means of
this menu option. By setting it to zero the function is disabled.
In “ECO” mode, the target temperature of the boiler is reduced by a preset value (see the
following menu option).
The vending machine remains in its “Ready” status and no message is shown to the user.
To exit the "ECO" mode, press any button or insert some credit.
When "ECO" mode is deactivated, the target temperature for boiler 2 is restored and the
machine starts the warm-up phase.
Eco timeout
1.5.2.
The “Stand-by” mode is activated after some minutes of inactivity which can be set by
means of this menu option. By setting it to zero the function is disabled.
In“Stand-by” mode the coffee and steam boilers are turned off (instant product boiler
remains on) and the display shows the message “Stand-by”.
To exit the “Stand-by” mode, press any button or insert some credit.
When normal operation is restored, the boilers are turned on and the vending machine
starts the warm-up phase.
Stand-by timeout
1.6. It allows enabling of the automatic rinsing of the mixing bowls.
Rinsing cycle
yes
1.6.1.
The automatic rinsing is performed as follows: the first rinsing takes place 10 minutes after
the “machine ready” status; if necessary, other rinses occur 7 hours after the last dispensing.
Automatic
1.6.2.
Programmable
1.7. Enables instant pre-grinding of the coffee dose.
Pre-grinding
yes
1.8.
Allows setting timing and amounts for preheating and precooling for instant product circuits
and for the coffee brew group.
Heating/cooling
00
1.8.1-5 Settings for the preheating of water circuits (cups/mixers).
Before dispensing a hot product, a hot rinse of the circuit must be performed, if:
the circuit remained idle for a longer time than that set in the “Timeout Heat. Mixer” and
the amount of water expected for the instant product is <=120 units.
Or if:
The circuit has to be used for a hot product after the same had been used for a cold
product.
The options in this menu allow setting the amount of water used for rinsing each water
circuit and the time of inactivity (expressed in minutes) after which the rinse starts.
Important note:
by setting the time of inactivity to zero preheating is disabled.
Instant prod. preheat.
1.8.1.6.
Mix. Heat Time-out
1.8.2. Settings for the preheating cycle of the brew group.
Coffee preheating
1.8.2.1.
Time (expressed in minutes) of brew group inactivity after which the group starts
preheating.
By setting it to 0, the preheating is disabled.
Operation after(min)
1.8.2.2. Increase in the water dose (in ml) for the first coffee (by first coffee we understand the
coffee for which the preheating of the brew group is activated).
Extra Coffee Dose