Saeco Cristallo 600 EVO, Use And Maintenance

Page: 43 / 112

English
8
43
8.9 Cup supply
Use only cups suitable for automatic dispensing. Do not
press them against each other during the loading
procedure.
Do not try to turn the
column manually.
When installing, with the cup dispenser empty, proceed as
follows:
• remove the cover of the cup dispensing tube.
• load two of the most accessible tubes.
• replace the cover on the cup columns.
8.10 First start-up of the vending
machine
Supply the vending machine (following the instructions
given previously) and plug it into the power supply (see
section "Power Grid Connection").
Now the message "Cristallo 400 / Cristallo 600" appears
on the display and the self-diagnosis phase is activated to
check the correct positioning of the machine devices.
During the self-diagnosis phase, the following devices are activated:
the brew group and the nozzle arm, to get a correct starting position;
if necessary, also the cup release motor, the cup holder and the
stirrer/sugar dispenser will be activated.
Instant products and coffee boilers are refilled also during the initialisation
phase (*).
When the initialisation is complete the warming phase starts and the
heating elements of the boilers are automatically switched on.
(*) During the initial start-up of the machine make sure the boilers are
actually full by starting the Maintenance and performing a refill of the coffe
boiler and a wash cycle
Carry out the grinder adjustment as indicated in the instructions at
section "Coffee Grinder Adjustment" after refilling the water circuit.
8.11 Water circuit filling
At first VM start-up, the boiler is filled automatically.
8.11.1 Filling the boiler manually
After switching the vending machine on it is possible to fill
the boiler by activating the following procedure:
Procedure A
• press the P2 key to enter the maintenance menu;
• Enter the Maintenance/Washes menu and start the
automatic washing cycle;
Procedure B
• press the P2 key to enter the maintenance menu;