RUTHMANN 27409, Operating And Maintenance Instructions Manual

Page: 117 / 261

6 Operation
BA.GB.12-27409-05-07-FTA-jr
RUTHMANN-Steiger
®
TB270
6-3
6.3 Switching on and off of hydraulic pump drive (power
take-
off)
Switching on:
Attention!
While the power take-off is switched on and as long as
the power take-off is switched on, the gas pedal must
not be actuated either directly or indirectly, e.g. through
the cruise control. The heating switch „Heat“ must not
be actuated.
Note
While the power take-
off is running (switch „power take-off“
actuated), the engine will automatically be switched-off if a
gear is engaged (driving motion) or if the hand brake is re-
leased. A switched-off engine cannot be started by means of
the ignition key if the power take-off is running and if the
hand brake is released.
Component Position/Indication
Execution in driver’s cab
Hand brake actuated actuate in acc. with the operating
instructions
of the chassis-
manufacturer.
Manual transmission neutral position in acc. with the operating instructions
of the chassis-manufacturer.
Vehicle engine runs start in acc. with the operating in-
structions of the chassis-manufac-
turer, in case vehicle engine is not yet
running.
Clutch pedal depressed completely depress
Power take-off on switch on in acc. with the operating
instructions of the chassis-manufac-
turer. If there is a gear aggregate
(slow / fast), this gear aggregate will
have an effect on the number of revo-
lutions of the power take-off (hydrau-
lic pump drive). See operating and