22
3.7 Feeding the machine
The feed hight is 1.100 mm above floor level. During manual feed no more than
50 kg of produkt should be put on to the machine.
for a comfortable operation a maximum of 25 kg is recommended.
3.7
.1The work bench
When the machine is positioned correctly the
work bench has a slope of 3° towards the
back of the machine.
This guarantees that the product slides safely into
the process chamber and liquid will run off
through the processing chamber after cleaning.
All sorts of preparations can be carried out on
the work bench, from arranging to cutting.
3.7.2
The shaft – charging
The filling of the shaft is decisive for the cut appearance.
that’s why special care has to be taken when filling the
shaft.
Following rules should be observed in order to achieve the best results:
....put as much product as possible into the shaft
....never use very hard and very soft product at the same time
....put fat, tendons and vleece towards the top
Only use products which are approved and mentioned by name in the processing programs of the
operating terminal.
If other products are intended to be used then written approval of Rühle is required.
Summary of Contents for SR1 turbo
Page 5: ...5...
