26
r. Untertake a visual check for cleanlyness of the machine and the attachments and repeat the
the cleaning steps ”L to N ” if required.
s. Fill the disinfectant solution into a pressure cleaner with a power rating of at least 3 bar,
spray the solution onto the machine and the attachments and wait for 20 minutes.
t. Use drinking water from a water hose or a pressure cleaner to hose down the machine and the
dismantled attachments in the temperature range from 50 – 60 °C, followed by drying
with compressed air, which is suitable for food (according to DIN ISO 85731-1).
u. Assemble the machine following the sequence ”K --> A”.
5. Technical service
All works which have to do with the technical service are only allowed to be carried out by
Rühle technicians and by persons with a written approval from Rühle. A difference is made
between regular maintenance and regular service, so that the approval has to be valid for the
respective service.
5.1 Regular maintenance
Regular maintenance has to be carried out at least once a week. This allows little errors or
wear and tear to be detected before a major damage occurs.
Not performing regular maintenance leads to technical consequences and a loss in quality of the
product. Irregularities discovered during regular maintenance have to be rectified immediately.
Apart from the machine system which is covered by the Rühle guarantee, there are parts which
are not wear resistant and are parts which are not wear resistant and are there fore not covered
by guarantee. With the High-Tech-Cutters SR1 and SR1 turbo grid knives, cutting blade and grid
drive bolts are such parts.
Maintenance plan
a.
Dismantle machine according to the cleaning instruction and check for ease of operation,
abrasion of material and any traces of wear and tear.
b.
Sharpen the sectioning blade with the sharpener and inspect the blade for
damage.
c.
Sharpen the blade of the processing shaft – sliding fastener on the top side and inspect for
damage.
Inspect the sliding surface of the sliding fastener.
d.
Sharpen the Multi-cutter knives of all Multiplex-cutter-halves with the sharpener and inspect for
damage.
Summary of Contents for SR1 turbo
Page 5: ...5...
