17
3.4.1 HighTech-cutter selection
This operating manual contains the correct grid selection for SR 1 and SR 1 turbo.
For the selection of the HighTech-cutter frame the following applies: Always select the frame
with the smallest number of slits. This results in the best cut.
Of course it is possible to take a HighTech-cutter frame with lots of slits.
Because a soft product is processed in this example and a Multiplex-cutter-half bottom is used, it is
possible to use product stabilizers.
3.4.2 HighTech-cutter assembly
The operator assembling the Multi-cutter has to wear protective gloves against cuts and stabs.
A.At first all necessary Multi-cutter parts have to
be put on a table with a non slippery surface.
Only use as many product stabilizers as
determined by the Multiplex-cutter-half bottom.
Is there provision for only one knife, only put one
knife on the table, never more.
Check the knives for damage and bluntness
without touching them with the hands.
Only if all parts don‘t show any signs of wear and
tear it ist allowed to assemble the Multi-cutter.
B.Put the bottom Multiplex cutter half with the
knife-edge facing down on to the bottom four
rollers of the Multi-cutter frame. Slide the Multiplex
-cutter half along the rollers until all four rollers
have engaged. The hook of the Multiplex
-cutter-half has to be on the right
hand side.
Summary of Contents for SR1 turbo
Page 5: ...5...
