19
3.4.3 HighTech-cutter
installation
Only install the Multi-cutter, which is nominated in the desired cutting program. The operator has to
wear protective gloves against cuts and stabs while working in the cutting area.
A.
Open the processing shaft and remove
the shaft slider by sliding it diagonally
out of the guides on the side.
B.
Turn the blade away from the cutting area,
so that the tip of the blade points to the floor.
C.
Before sliding the Multi-cutter into the Multi-
cutter fastener, it has to be inserted into the sector
of the sheet metal as high up as possible.
Now the Multi-cutter can be inserted into the
fastener.
D.
Turn the blade on the knife shaft twice by 360°.
If this can be done without any problems, the
process shaft and the cutting area door can be
closed again.
If it is not possible to turn the blade two
revolutions or to lock the shaft, it has to be
checked if the drive bolts have engaged properly in the drive hooks of the Multiplex-
cutter half.
After checking and rectifying the problem, the
blade again has to be turned twice by 360°.
Summary of Contents for SR1 turbo
Page 5: ...5...