3
1. Safety Instructions
!!! The safety instructions have to be observed during the installation, operation, cleaning and
servicing of the Rühle High Tech Cutter type SR 1 and SR1 turbo.
1.1 Safety hints
!!! The operating manual has to be read by the supervising personal before installation, operation,
cleaning or servicing. The supervising personal has to make sure, that the operator as well as
the persons cleaning and servicing the machine, have read and understood the operating
manual.
!!! The operator has to operate the machine as directed and strictly pay attention to all points of the
operating manual. The supervisor has to write an instruction for the intended use of the
machine.
!!! Before starting up the machine, the operator has to check the functionality of the following
safety devices on a day to day basis:
A.
Visual control on all sides of the machine for changes or damage. In
case of changes or damage, the machine has to be shut down.
B.
Close the door to the cutting area – lock discharge funnel inside the cutting area
door – start the machine – open the cutting area door 20 mm. Should the machine
not stop it has to be shut down immediately.
C.
Close the door to the cutting area – close process shaft – start the machine – open
the process shaft. If the machine doesn’t stop, it has to be shut down immediately.
D.
Lock the brakes of the casters at the back. – Try to move the machine by pushing
it. – Select a different location if the machine moves and shut the machine down
immediatly should the new location result in movement again
To shut down the machine, the main switch has to be turned to position”0”. Additionaly, the
main switch has to be secured by a pad lock. The key has to be handed over to the
supervisor. The mains plug has to be disconnected from the power outlet.
!!! The supervising personal has to make sure, that the malfunctioning safety devices
are repaired by a Rühle technician. It’s the supervisors responsibility, that the machine isn’t
used under any circumstances until the repairs have been carried out.
!!! The cleaning personal has to observe the cleaning instructions.
The supervisor has to write instructions for a safe cleaning procedure.
!!! The maintenance personal is only allowed to service the machine within the guidelines of
”regular maintenance 5.1” unless written permission has been given by the manufacturer
to do otherwise. The supervisor has to write instructions for safe maintenance works.
Summary of Contents for SR1 turbo
Page 5: ...5...