Ruckus Wireless ZoneDirector 3000, User Manual, Page: 359 / 430

Setting Mesh Uplinks Manually
On Dual-band ZoneFlex APs
ZoneDirector 9.8 User Guide, 800-70599-001 Rev B
359
Figure 190. Setting Uplink Selection to Manual
NOTE: Do not manually set a Mesh AP as a Root AP. Only APs that are connected
to ZoneDirector via Ethernet (and on the same LAN segment) should be configured
as Root APs. Mis-configuring a Mesh AP or an eMAP as a Root AP can cause the
AP to become isolated, or, in the case of eMAP, can result in a network loop.
To set the mesh uplink for an AP manually:
1 On the ZoneDirector web interface, click the Configure tab.
2 On the menu, click Access Points .
3 In the Access Points table, find the AP you want to restrict, and click Edit under
the Actions column. The editing form appears below your selection.
4 Under Advanced Options > Uplink Selection , select the Manual radio button.
The other APs in the mesh appear below the selection.
5 Select the check box for each AP that the current AP can use as uplink.
NOTE: If you set Uplink Selection for an AP to Manual and the uplink AP that you
selected is off or unavailable, the AP status on the Monitor > Access Points page
will appear as
Isolated Mesh AP .
6 Click OK to save your settings.