Ruckus Wireless ZoneDirector 3000, User Manual, Page: 237 / 430

Working with Access Point Groups
Modifying Model Specific Controls
ZoneDirector 9.8 User Guide, 800-70599-001 Rev B
237
5 Deselect the check box next to Enable to disable this LAN port entirely. All ports
are enabled by default.
6 Select
DHCP_Opt82
if you want to enable this option for this port (see “DHCP
Option 82” ).
7 For any enabled ports, you can choose whether the port will be used as a Trunk
Port
, an
Access Port
or a
General Port
. The following restrictions apply:
• All APs must be configured with at least one Trunk Port.
• For single port APs (e.g., ZoneFlex R300), the single LAN port must be a
trunk port and is therefore not configurable.
• For ZoneFlex 7025/7055, the LAN5/Uplink port on the rear of the AP is
defined as a Trunk Port and is not configurable. The four front-facing LAN
ports are configurable.
• For all other APs, you can configure each port individually as either a Trunk
Port, Access Port or General Port. (See
Designating Ethernet Port Type for
more information.)
8 (If Smart Mesh is not enabled), choose whether this port will serve as an 802.1X
Authenticator or Supplicant, or leave 802.1X settings disabled (default). (See
Using Port-Based 802.1X for more information.)
9 Click Apply to save your changes.