28 Installation
KP-3016/3016A Series
Bosch Security Systems, Inc.
Technical Manual
F.01U.315.927
Rev. 02
8.
Position both pieces of
shrink-tubing
so any portion of the cable without an outer insulation layer is covered.
9.
Using a heat gun, apply
even heat over the length and diameter of the tubing
(minimum temperature 100°C).
IMPORTANT:
Since uncontrolled heat can cause uneven shrinkage, physical damage, and insulation failure, the use of
open flame is not recommended. Avoid overheating the heat shrink-tubing because it can become brittle
and/or charred.
10.
Gently push the
headset connector cable
back into the unit.
11.
Align the
rib on the headset connector with the notch in the connector opening
and press the connector
completely in.
12.
While holding the connector in place, turn the
set screw clockwise
to tighten the connector in position.