128 KP-3016/3016A Menu System
KP-3016/KP-3016A Series
Bosch Security Systems, Inc.
Technical Manual
F.01U.315.927
Rev. 02
Service Menu, OMNEO Setup (KP-3016 Only)
The
OMNEO Setup
menu option is used to configure the OMNEO device name, enable DHCP, address the OMNEO device
for the keypanel and set up the static IP configuration, if DHCP is disabled.
IMPORTANT:
If you change the device name on the keypanel, you must change how other device are configured, so
they can continue to make connection offers to this keypanel.
To
enable DHCP from the keypanel
, do the following:
1.
Starting at the Service|OMNEO Setup menu, select
OKP
.
NOTE:
OKP refers to the OMNEO keypanel using the OMNEO connection; however, if an OEI-2 is also attached to
the AIO port, you see both OKP and OEI-2 options for selection.
2.
Press the
SEL button
.
Device Name, DHCP, and IP Parameters appear in the panel display
.
3.
Using the AUX/MENU shaft encoder,
select
DHCP
.
4.
Press the
SEL button
.
Disabled and Enabled appear in the panel display.
5.
Using the AUX/MENU shaft encoder,
select
Enabled
.
6.
Press the
SEL button
.
7.
Press the
CLR
button to exit the menu.
To
configure the OKP’s device name
, do the following:
1.
Starting at the Service|OMNEO Setup menu, select
OKP
.
2.
Press the
SEL button
.
Device Name, DHCP, and IP Parameters appear in the panel display
.
3.
Using the AUX/MENU shaft encoder,
select
Device Name
.
The name of the OKP card appears in the panel display with the first character of its name blinking
.
4.
Using the AUX/MENU shaft encoder, select a
new character at the current position
.
5.
Using the MAIN shaft encoder, move to the
next or previous character position
.
6.
Press
SHIFT
to insert a character at the current position.
7.
Press the
SEL button
.
OR
Press the
AUX
shaft encoder to move to the next character.
NOTE:
Press the MAIN shaft encoder to cancel editing. A confirmation is required.
8.
Repeat
steps
4
and
7
until you have modified the device name.
9.
Move to the end of the name and press the
SEL button
(or the AUX shaft encoder) to save changes.
The message Save Name? appears on the panel display.
10.
Press the
SEL button
.
To
configure the OKP IP parameters
, do the following:
1.
Starting at the Service|OMNEO Setup menu, select
OKP
.
2.
Press the
SEL button
.
Device Name, DHCP, and IP Parameters appear in the panel display
.
3.
Using the AUX/MENU shaft encoder, select
DHCP
.
4.
Press the
SEL button
.
Disabled and Enabled appear in the panel display.