ANY DAMAGE TO THE MACHINE DEVICES
RESULTING FROM THE USE OF LUBRICANTS
OTHER THAN THOSE RECOMMENDED IN THIS
MANUAL WILL RELEASE THE MANUFACTURER
FROM ANY LIABILITY!!
13.1
Rim arms calibration
Make sure that the bead rollers and the tool take place correctly in
comparison to the rim, as described hereafter:
1. Mount a rim in good conditions (not ovalized and not bent)
without tire on the machine.
2. Lock the rim with the locking shaft assembly.
With machine in manual mode
1. Move the arms horizontally to place the upper bead roller in
contact with the rim, as indicated in
Fig. 53
.
2. Check that the lower bead roller takes place at about 1÷2 mm
(1/24”) and the tool at about 2 mm (1/12”) from the rim edge, as
indicated in the
Fig. 53
.
Fig. 53
33
