Ross SRG-4400, User Manual

Page: 26 / 193

2–8 • Physical Installation SRG-4400 User Manual (Iss. 06)
Figure 2.3 Installing the Breakout PCB and Tray to the Rear Brackets.
2. Use the 4 provided M3 5mm screws to affix the Breakout PCB and Tray to the Rear
Brackets of the SRG-4400. Refer to
Figure 2.3 .
Connecting the Breakout PCB to the SRG-4400
The Breakout PCB connects to the SRG-4400 rear panel via the provided Interface Cable
(4400CR-100). This cable type has red and violet wires, and two 30-pin Connectors.
For More Information on...
• using the Breakout PCB in a redundant system with an ACO-4400A, refer to the
ACO-4400A User Manual .
To connect the Breakout PCB to the SRG-4400
1. Connect one end of the Interface Cable to the connector on the Breakout PCB.
Figure 2.4 Connecting the Breakout PCB to the SRG-4400 Rear Panel
GPI/RS232
100-BaseT
1Hz
10MHz IN
10MHz
WK/TTL1
WK/TTL
2
COMPOSITE
6Hz/TTL3
DARS
AES 1
AES 2
REF LOOP
BLACK 1
SRG-4400
REAR BRACKET
PCB
TRI/BLACK 2
TRI/BLACK 3
TRI/BLACK 4
SDI 2 BLACK
SDI 1 BLACK
SDI 2
TRA
Y
REAR BRACKET
GPS
BALANCED AUDIO/AES/L
TC
SDI 1
GPI/RS232
100-BaseT
1Hz
10MHz IN
10MHz
WK/TTL1
W
K/TTL
2
COMPOSITE
6Hz/TTL3
DARS
AES 1
AES 2
REF LOOP
BLACK 1
TRI/BLACK 2
TRI/BLACK 3
TRI/BLACK 4
SDI 2 BLACK
SDI 1 BLACK
SDI 2
GPS
BALANCED AUDIO/AES/L
TC
SDI 1
SRG-4400
PCB
TRA
Y