Ross SRG-4400, User Manual

Page: 24 / 193

2–6 • Physical Installation SRG-4400 User Manual (Iss. 06)
Installing the Breakout PCB
The Breakout PCB for the SRG-4400 enables you to cable a Primary SRG-4400 and a Backup
SRG-4400 to an ACO-4400A but still retain access to the AES, DARS, and Analog Audio
connections on balanced 3-pin connectors.
Installing the Breakout PCB requires:
1. Installing the Breakout PCB on the Rack Tray
2. Installing the Breakout PCB into the Rack Frame
3. Connecting the Breakout PCB to the SRG-4400
4. Cabling the Connectors on the Breakout PCB
Before You Begin
Before installing the Breakout PCB, refer to the section “ Important Regulatory and Safety
Notices to Service Personnel ” located at the front of this manual for power source, grounding,
and other general safety information.
Static Discharge
Throughout this manual, please heed the following cautionary note:
Unpacking
Unpack each SRG-4400 Install Kit you received from the shipping container and ensure that all
items are included. If any items are missing or damaged, contact your sales representative or Ross
Video directly.
Required Equipment
Table 2.1 summarizes the items that are required
ESD Susceptibility
— Static discharge can cause serious damage to sensitive
semiconductor devices. Avoid handling circuit boards in high static environments such as
carpeted areas and when synthetic fiber clothing is worn. Always exercise proper grounding
precautions when working on circuit boards and related equipment.
Table 2.1 SRG-4400 Install Kit Items
Part Number Description Quantity
70-00994 Rack frame tray for the Breakout PCB 1
8399AR-032 Breakout PCB 1
4101-3004-RC M3 5mm screws for the rear brackets and tray 8
88-00995 M3 10mm screws with lock washers 4
4400CR-100 30-pin Molex cable (red and violet wires) 1