Ross SRG-4400, User Manual

Page: 52 / 193

4–8 • Operating Basics SRG-4400 User Manual (Iss. 06)
3.
Verify that the Ross System Update Tool and data files are in the same folder on the PC.
To upload software files to the SRG-4400
1.
On your PC, launch the “
RossSystemUpdate_v#.#.#.#.exe
” program.
The Ross System Update dialog opens.
Ross System Update Dialog
2. Set the IP Address and IP Mask fields to the values for the SRG-4400 you want to
upgrade. Note that all octets must be entered as 3-digits. For example, 255.0.0.0 should
be entered as 255.000.000.000.
3. Click Get Device Mode .
The status field, located above the Ross logo, updates to display: “
The device is in
Application mode.
”.
4. If the SRG-4400 is “not found”:
a) Check again that all connections have been made.
b) Verify that the IP Address and IP Mask values were entered correctly in step 2.
c) Power off the SRG-4400.
d) Repeat step 1. to step 3.
5. If the SRG-4400 still cannot be found, contact Ross Video for further assistance.
6. There are 3 files that consist of a full upgrade. Only newer files than those on the unit
need be installed. The order they should be installed is as follows:
a) Pattern File (PatFile_xxxxx.ata)
b) FPGA File (XilFile_xxxx.ata)
c) Software File (ArmFile_xxxx.ata)
7. For each file:
a) Click Open File to display the Open File dialog.
b) Select the relevant “*.ata” file.
c) Click
OK to load the file into the Ross System Update Tool and close the Open File
dialog.
d) Click Send to Device .
e) If this is the first file to be uploaded, you will be asked to confirm the upload.
8. Monitor the upload:
a) The software will put the SRG-4400 into Bootload mode.
b) The Ross System Update Tool erases the old SRG-4400 file.
c) The Ross System Update Tool uploads the new file to the SRG-4400. Upload of a
file takes approximately 1 minute.