Ross SRG-4400, User Manual

Page: 39 / 193

SRG-4400 User Manual (Iss. 06) Functional Check Procedures • 3–9
• AES 2 01 …. 02 etc, to
• AES 8 01 …. 02
Before proceeding, connect a suitable Breakout cable/box to the 30-pin Multi-way connector on
the rear panel.
From the Top Level menu:
1.
Select < -Audio >.
2.
Select < Audio AES1 Left = Audio 01 >.
3.
From the Breakout cable/box, connect AES Audio Channel 01 to your Digital Audio
Analyzer input.
4.
Set the Digital Audio Analyzer to display the status of the audio data, and to receive a
signal through the connected input.
5.
Check that the Analyzer does not report any data errors, etc.
6.
Check that the Digital Audio signal is as configured in the menu, and that selecting and
editing entries in the menu by using the rotary/push control, the configuration of the
Digital Audio signal changes accordingly.
7.
Repeat steps 3 - 6 for menu selection
< Audio AES1 Right = Audio 02 > and breakout connection AES Audio Channel 02.
8.
Repeat steps 3 - 6 for menu selections:
< Audio AES 2….6 Left / Right = Audio 03….12 > and breakout connections AES
Audio Channel 03 through 12.
9.
AES7 and AES8 Audio outputs will only appear on the rear panel multi-way connector
of the sub-module if the relevant menu items have been suitably configured. Refer to the
section “
System Functions ” on page 3-11 for more details on where these settings are.
10.
Repeat steps 3 - 6 for menu selections:
< Audio AES 7….8 Left / Right = Audio 13….16 > and breakout connections AES
Audio Channel 13 through 16.
11.
Return to the Top Level menu using the [ Back ] button.
Analog Audio Outputs
Audio channels on the Analog Audio outputs are arranged as a stereo pair: Analog 01 … 02
Before proceeding, connect a suitable Breakout cable/box to the 30-pin Multi-way connector on
the rear panel.
From the Top Level menu:
1.
Select < -Audio >.
2.
Select < Audio Analogue1 Left = Audio 01 > [2nd to last entry in the list].
3.
From the Breakout cable/box, connect Analogue Audio Channel 01 to your Analog
Audio Analyzer input or to an oscilloscope.
4.
Set the Analog Audio Analyzer / oscilloscope to display the audio signal, and to receive
a signal through the connected input.
Note
— Analog Audio Outputs are only available when the multifunction sub-module is
installed.