Ross SRG-4400, User Manual

Page: 51 / 193

SRG-4400 User Manual (Iss. 06) Operating Basics • 4–7
Software Upgrades
This upgrade procedure applies to SRG-4400 systems where an Ethernet connection is installed.
It outlines the steps necessary to upgrade the software programmed on the main module.
Before You Begin
Before starting, ensure that you comply with the following requirements:
• Connect the SRG-4400 via an Ethernet cable to your local network.
• A PC, also connected via Ethernet to your local network, with the supplied update
program(s) and associated data file(s) available. Ideally, data file(s) should be located in
the same folder as the associated update program.
• A power-cycle is required as part of a data file update.
• Ensure that you have the
RossSystemUpdate_Vx.x.x.x.exe program. Contact Ross
Technical Support for this program.
Uploading the Software Files
Table 4.1 lists the applicable files for your SRG-4400.
Only newer files need to be loaded. Depending on the situation, an upgrade may consist of one of
the following scenarios:
• Full upgrade — Requires the Pattern, FPGA file, and Software files
• Pattern File upgrade — Requires the Pattern files only
• Software upgrade — Requires the Software file only
• Firmware upgrade — Requires the Firmware file only
To prepare for the upgrade
1.
Connect the SRG-4400 via an Ethernet cable to your local network.
2.
Connect a Windows PC to the network, such that the SRG-4400 is visible.
Important
— Performing a software upgrade to the SRG-4400 requires the unit to be
rebooted, and may be off-line for several minutes. Ensure that your system is not in use.
Important
— Do not re-name any of the files.
Table 4.1 SRG-4400 Files
File Type Description
Bootware
Bootloader At present, can only be uploaded at the factory.
Patfile
Pattern Files
Can be uploaded while the SRG-4400 is in operation.
When complete, a power cycle is required.
Xilfile
FPGA File
Requires that the SRG-4400 is in Bootloader mode.
When complete, a power cycle is required.
ArmFile
SRG-4400 Software
Requires that the SRG-4400 is in Bootloader mode.
When complete, a power cycle is required.