Roland TrueVIS VG2-540, User Manual

Page: 110 / 319

MEMO
When you send the output data, "FILLING" or "CLEANING" may be displayed on the screen. These indicate the preparation
operations performed before output. Output will begin after the time displayed on the screen elapses.
IMPORTANT
Output Is Not Possible in These Situations
• The machine does not run when a cover (front, left, right, or ink slot) is open.
• Data from the computer is not accepted when [SETUP] is dark.
• Printing does not start until [HEATER] lights. However, in the following cases printing is possible even if [HEATER] is not lit.
• The settings for "PRINT" (print heater) and "DRYER" are "OFF".
P. 153
「
Setting the Print Heater Temperature
」
P. 154
「
Setting the Dryer Temperature
」
• Heater settings "POWER" is "OFF."
P. 160
「
Switching Off the Print Heater and Dryer Together
」
• Data from the computer is not accepted when you are not at the top menu.
Points that must be observed
• Never open a cover (front, left, or right) while output is in progress. Doing so interrupts printing.
• When you are performing printing, clamp the edges of the media with the media clamps. Otherwise, the edges of the media
may warp and catch on the print heads.
• During output, do not touch the media. Doing so may obstruct the media feed or cause the media to rub against the print
heads, which may result in a paper jam or damage to the heads.
• Keep the loading lever raised when the machine is not in use.
When not using the machine, remove any media and store it in a suitable environment.
• If the machine is left with the media loaded, the media may be damaged, which may adversely affect printing. When not
using the machine, remove any media and store it in a suitable environment.
Printing and Cutting Output
3. Printing and Cutting Method
109